Spa and Hot Tub Covers
Heavy Density Foam Sloped 4" to 2"
Three Year Warranty ( Click Here)
All covers up to 96"..
4" - 2'' Slope
$375.00
Including Shipping to a business Location
Now A Spa Cover that Holds its own weight and yours Too!
Our Spa Cover Can Hold Up to 250 lbs. Of Dead Weight Load, On MID SIZE COVERS (ABOUT 84") with the 4-2 slope 2#
The cover should Not be walked on! It is designed to hold Dead weight, like Snow... Etc.
With the High Cost of Heating your Spa, our Cover can cut your Heating Cost By 80% compared to not using a cover at all. The Slope Design allows Water to run off the Cover Extending the Life of the Cover.
Best Viewed In Internet Explorer
THE CONSTRUCTION OF THE COVER
* Marine Grade Vinyl is used on the exterior of the cover
Vinyl Properties:
28oz expanded vinyl
Weatherometer (1500/hrs Minimum)
U.V. Resistant pigments(500/hrs Minimum)
100% Polyester Backing
Antimicrobial treated (Mold & mildew)
-20 Deg. Cold Crack
100% Virgin Vinyl
* The Inserts are 4" to 2" Sloped R value of 16.
*The Density is 2# per cubic ft. Wrapped and HEAT SEALED in a 4 Mil treated Plastic.Don't be Misled about Vapor seals!! WATER cannot pass through Plastic NO MATTER what the mill thickness is All that a heavier mil plastic does is add weight to the cover
* The Inserts are supported with an Aluminum "C"
Channel for maximum support. Other company's use a
Galvanized C Channel.
*Here is what it looks like after a few
years (click here)
* The two halves of the cover are hinged with a reinforced hinge for many years openings and closings. A heat seal tub is sewed in between the two halves to seal the gap
(Click here for a Close-Up View)
* The bottom of the cover is made of an open vinyl mesh: allowing moisture to drip back into the tub as well as letting the the cover breathe when it is off the tub.
* The handles and tie down straps are reinforced with nylon and sewed into the skirt for maximum strength.
*Placement of the Handles and Tie down Straps are 36" Apart on the Ends parallel to the Hinge
* The Zippers are nylon and the zipper pulls are baked enamel to prevent rust and corrosion.
* We use a Polyester (size 92) Heavy weight Thread to prevent Deterioration from the Sun And Weather.
* The zippers are double stitched,and the entire cover has top stitching around the skirt.
(can be seen in the Close-Up View)
* The standard skirt is 2" from the bottom of the cover, Spilt at the corners to lay out easily .
IN NEED OF A NEW HOT TUB?
Choose
Hot Tubs Direct Hot Tub, Portable Spa & Swim Spa Mega Store
For
Hot Tubs, Portable Spas & Swim Spas, Call Our Partner @ 1-888-611-8827 (TUBS)!
Take A look at Our Colors
Click here COLORS
